Effect of Solution Spray Rate on the Properties of Chemically Sprayed ZnO:In Thin Films

الملخص EN

ZnO:In thin films were grown from 100 mL of spray solution on glass substrates by chemical spray at Ts=400°C using solution spray rates of 0.5–6.7 mL/min.

Zinc acetate and indium(III)chloride were used as Zn and In sources, respectively, with [In]/[Zn] = 3 at.%.

Independent of solution spray rate, the crystallites in ZnO:In films grow preferentially in the (101) plane parallel to the substrate.

The solution spray rate influences the surface morphology, grain size, film thickness, and electrical and optical properties.

According to SEM and AFM studies, sharp-edged pyramidal grains and canvas-resembling surfaces are characteristic of films grown at spray rates of 0.5 and 3.3 mL/min, respectively.

To obtain films with comparable film thickness and grain size, more spray solution should be used at low spray rates.

The electrical resistivity of sprayed ZnO:In films is controlled by the solution spray rate.

The carrier concentration increases from 2·1019 cm−3 to 1·1020 cm−3 when spray rate is increased from 0.5 mL/min to 3.3 mL/min independent of the film thickness; the carrier mobilities are always lower in slowly grown films.

Sprayed ZnO:In films transmit 75–80% of the visible light while the increase in solution spray rate from 0.5 mL/min to 3.3 mL/min decreases the transmittance in the NIR region and increases the band gap in accordance with the increase in carrier concentration.

Lower carrier concentration in slowly sprayed films is likely due to the indium oxidation.