Design and Fabrication of Nanoscale IDTs Using Electron Beam Technology for High-Frequency SAW Devices

الملخص EN

High-frequency Rayleigh-mode surface acoustic wave (SAW) devices were fabricated for 4G mobile telecommunications.

The RF magnetron sputtering method was adopted to grow piezoelectric aluminum nitride (AlN) thin films on the Si3N4/Si substrates.

The influence of sputtering parameters on the crystalline characteristics of AlN thin films was investigated.

The interdigital transducer electrodes (IDTs) of aluminum (Al) were then fabricated onto the AlN surfaces by using the electron beam (e-beam) direct write lithography method to form the Al/AlN/Si3N4/Si structured SAW devices.

The Al electrodes were adopted owing to its low resistivity, low cost, and low density of the material.

For 4G applications in mobile telecommunications, the line widths of 937 nm, 750 nm, 562 nm, and 375 nm of IDTs were designed.

Preferred orientation and crystalline properties of AlN thin films were determined by X-ray diffraction using a Siemens XRD-8 with CuK α radiation.

Additionally, the cross-sectional images of AlN thin films were obtained by scanning electron microscope.

Finally, the frequency responses of high-frequency SAW devices were measured using the E5071C network analyzer.

The center frequencies of the high-frequency Rayleigh-mode SAW devices of 1.36 GHz, 1.81 GHz, 2.37 GHz, and 3.74 GHz are obtained.

This study demonstrates that the proposed processing method significantly contributes to high-frequency SAW devices for wireless communications.