Sensitivity Improvement of Ammonia Gas Sensor Based on Poly(3,4-ethylenedioxythiophene)‎:Poly(styrenesulfonate)‎ by Employing Doping of Bromocresol Green

الملخص EN

The aim of this research is to improve the sensitivity of ammonia gas sensor (hereafter referred to as sensor) based on poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate) (PEDOT:PSS) by employing the doping dye of bromocresol green (BCG).

The doping process was carried out by mixing the BCG and the PEDOT:PSS in a solution with an optimum ratio of 1 : 1 in volume.

The sensor was fabricated by using spin-coating technique followed by annealing process.

For comparison, the BCG thin film and the PEDOT:PSS thin film were also deposited with the same method on glass substrates.

For optical characterization, a red-light laser diode with a 650 nm wavelength was used as light source.

Under illumination with the laser diode, the bare glass substrate and BCG film showed no absorption.

The sensor exhibited linear response to ammonia gas for the range of 200 ppm to 800 ppm.

It increased the sensitivity of sensor based on PEDOT:PSS with BCG doping being about twofold higher compared to that of without BCG doping.

Furthermore, the response time and the recovery time of the sensor were found very fast.

It suggests that the optical sensor based on BCG-doped PEDOT:PSS is promising for application as ammonia gas sensor.