Fatigue life improvement of spheroidal and compacted graphite cast iron

المؤلفون المشاركون

al-Nawafilah, Muhammad Salim
al-Tarawinah, Muwaffaq

المصدر

Mu'tah Journal for Research and Studies : Natural and Applied Sciences Series

العدد

المجلد 25، العدد 1 (31 ديسمبر/كانون الأول 2010)، ص ص. 11-20، 10ص.

الناشر

جامعة مؤتة عمادة البحث العلمي

تاريخ النشر

2010-12-31

دولة النشر

الأردن

عدد الصفحات

10

التخصصات الرئيسية

هندسة المواد والمعادن

الملخص AR

إن تحسين أداء الأجسام الميكانيكية و زيادة العمر التشغيلي للمعادن تعتبر من المتطلبات الصناعية ذات الأهمية.

كما أن تخفيف الأثر السلبي لشدة الكلل في المعادن و التنبؤ المبكر عن ظاهرة حدوث الفشل تعتبر من الاهتمامات البحثية التي تخدم الصناعة.

يهدف هذا العمل إلى إيجاد طريقة عملية و ذات كلفة منخفضة لتخفيف شدة الكلل و تجنب حدوث الفشل المبكر حيث تم تطبيق الية التوافق المحوري التي أظهرت درجة من التحسن و ذلك شدة الكلل.

تم إجراء الفحص المخبري على عينتان من الأشكال الكروي و المدمجة من معدن حديد الزهر الكربوني و ذلك لدراسة و تقييم تأثير الانحناءات متغيرة الاتجاه حيث أخضعت العينتان إلى ظروف تشغيلية من الأحمال الدنيا و القصوى لأجل تحديد حدوث الكلل الدنيا و القصوى.

أجري الفحص على درجة حرارة المختبر و بنسبة كلل = .1- و أخذت القراءات و الملاحظات على مرحلتين منفصلتين و هما : مرحلة تأثير الأحمال الدنيا حيث تم تشغيل التجربة لما يعادل 7*106 دورة حيث تم تحديد حدود الكلل الدنيا بناء على بداية ظهور التشققات على الأسطح و من ثم توقف اتساع هذه التشققات.

أما بالنسبة للأحمال القصوى فقد تم تحديد حدود الكلل القصوى قبل حدوث ظاهرة الفشل.

أثبتت النتائج بأن تطبيق التوافق المحوري هي طريقة واعدة و عملية, حيث درجة من التحسن و ذلك بانخفاض شدة الكلل في الأشكال الكروية بمقدار من التحسن يعادل 8,96 درجة, و في الأشكال المدمجة بمقدار 7,34 درجة.

الملخص EN

In this research the effect of coaxing on the fatigue strength of spheroidal and compacted graphite cast iron was studied.

The stress-stress cycle curves for both irons were established and the fatigue limits (6W) were determined.

They were 185 MPa for spheroidal graphite cast iron (SGI) and 175 MPa for compacted graphite cast iron (CGI).

Then samples were subjected to two steps loading; namely low-high loading.

The initial loading was 182 MPa for SGI which is lower than the 6W for SGI by 3 MPa and the initial loading was 172 MPa for CGI which is lowsr than 6w for CGI by 3 MPa.

For both irons the tests were run for 7x106 cycles at the lower range of loading until the cracks started to appear and stopped from growing, then specimens were subjected to higher stresses; namely 220 MPa for SGI and 210 MPa for CGI until failure of the specimens occurred.

The results obtained for the coaxing phenomenon in SGI showed 8.96 folds improvement and 7.34 folds for CGI in fatigue life.

The tests were done at room temperature at a stress ratio of R= -1.

The specimens were in form of strips which were subjected to alternating bending fatigue test.

نمط استشهاد جمعية علماء النفس الأمريكية (APA)

al-Nawafilah, Muhammad Salim& al-Tarawinah, Muwaffaq. 2010. Fatigue life improvement of spheroidal and compacted graphite cast iron. Mu'tah Journal for Research and Studies : Natural and Applied Sciences Series،Vol. 25, no. 1, pp.11-20.
https://search.emarefa.net/detail/BIM-253062

نمط استشهاد الجمعية الأمريكية للغات الحديثة (MLA)

al-Nawafilah, Muhammad Salim& al-Tarawinah, Muwaffaq. Fatigue life improvement of spheroidal and compacted graphite cast iron. Mu'tah Journal for Research and Studies : Natural and Applied Sciences Series Vol. 25, no. 1 (Dec. 2010), pp.11-20.
https://search.emarefa.net/detail/BIM-253062

نمط استشهاد الجمعية الطبية الأمريكية (AMA)

al-Nawafilah, Muhammad Salim& al-Tarawinah, Muwaffaq. Fatigue life improvement of spheroidal and compacted graphite cast iron. Mu'tah Journal for Research and Studies : Natural and Applied Sciences Series. 2010. Vol. 25, no. 1, pp.11-20.
https://search.emarefa.net/detail/BIM-253062

نوع البيانات

مقالات

لغة النص

الإنجليزية

الملاحظات

Includes bibliographical references : p. 15-16

رقم السجل

BIM-253062