Dynamic penetration into glasspolyester laminates loaded with bi-axialforces

العناوين الأخرى

تأثير قوى الاختراق الداينميكي بسرعة فائقة على مادة مركبة معرضة إلى قوى داخلية مستوية باتجاهين متعامدين

المؤلفون المشاركون

Naji, al-Agli Abd al-Muhsin
Gaafre, Mohaimen

المصدر

University of Thi-Qar Journal

العدد

المجلد 4، العدد 3 (31 ديسمبر/كانون الأول 2008)، ص ص. 105-120، 16ص.

الناشر

جامعة ذي قار قسم البحث و التطوير

تاريخ النشر

2008-12-31

دولة النشر

العراق

عدد الصفحات

16

التخصصات الرئيسية

الفيزياء

الملخص AR

في هذا البحث أجريت دراسة مختبرية و نظرية لسلوك مادة مكونة من خمسة طبقات من حصائر (E-glass Polyester) المغمورة في مادة البولستر و قد حملت بقوة داخلية باتجاه محور واحد و باتجاه محورين و معرضة لقوى صدم بسرعات عالية جدا.

لقد استخدمت قذائف (اطلاقات) ذات نهايات مستقيمة و محدبة و مدببة كما تمت دراسة تأثير تغيير الاستجابة للمادة المركبة لقوى الصدم نتيجة لتغيير شكل و مساحة الاختراق.

وجد من خلال المعطيات العملية أن الطاقة الممتصة من قل الهدف (المادة المركبة المضروبة) تقل كلما قلت مساحة التلامس الأولى مع الهدف أي (من الاطلاقة ذات النهاية المستقيمة إلى المحدبة إلى المدببة) كما وجد أن الهدف كلما كان محملا أكثر بقوى ضغط أحادي محوري أو ثنائي المحور تزداد الطاقة الممتصة و تقل سرعة الخروج و ينعكس ذلك على مقاومة المادة المركبة للاختراق و الثقب و تزداد حتى تصل (80%) من الحالة الاعتيادية كما لوحظ أيضا أن مساحة التأثير في منطقة الصدم تتأثر بشكل نهاية الاطلاقة حيث يزداد قطر دائرة التأثير كلما ازدادت مساحة التماس و أن أعلى مساحة يحدث فيها انفصال للطبقات حدثت عندما كان الضغط الداخلي من محورين (Bi-axail) مساوي (0.6KN) و ذلك باستخدام اطلاقة نهايتها مستقيمة أما النتائج النظرية المستخدمة من جراء استخدام برنامج (F.E.M) فقد أوضحت أن هناك عدة أشكال للانهيار و الفشل في حالة حدوث الاختراق و هي القص أو سحب و مد الطبقة الأولى أو باختراق و دفع و تحطيم أجزاء من الألياف في كل طبقة مما يعطي وثوقية لصمود لهدف و عدم فشله المفاجئ.

الملخص EN

The behavior of 5-plies woven E-glass fiber reinforced polyester composite laminates loaded with axial and bi-axial in plan forces under high velocity impact was investigated experimentally and numerically.

Three different projectile geometries namly blunt-ended, hemispherical and conical (30 half angle) ended were used to assess the effects of the projectile nose geometry on the response of the laminates.

It was founded that decreasing of the energy absorbed graduated from blunt to hemispherical to conical projectiles.

It was noticed that when increase the pressure the exit velocity.

Found to be increase.

It was found too that when composite plat put under certain value uniaxial or bi-axial compression offer more resistance to penetration and perforation reaching a value of about (80 %).It was noticed that effected area are increasing with increasing of contact area.

Also, the maximum delamination was occurre when higher Biaxial compression load (0.6KN) was subjected by Blunt-ended penetrator.

Theoretical work shows that each of three projectiles perforate the laminate with different modes, These are shearing action, stretching the primary yarns upto failure, Finally experimental results was pushing a part the filaments in each ply.

نمط استشهاد جمعية علماء النفس الأمريكية (APA)

Naji, al-Agli Abd al-Muhsin& Gaafre, Mohaimen. 2008. Dynamic penetration into glasspolyester laminates loaded with bi-axialforces. University of Thi-Qar Journal،Vol. 4, no. 3, pp.105-120.
https://search.emarefa.net/detail/BIM-276345

نمط استشهاد الجمعية الأمريكية للغات الحديثة (MLA)

Naji, al-Agli Abd al-Muhsin& Gaafre, Mohaimen. Dynamic penetration into glasspolyester laminates loaded with bi-axialforces. University of Thi-Qar Journal Vol. 4, no. 3 (Dec. 2008), pp.105-120.
https://search.emarefa.net/detail/BIM-276345

نمط استشهاد الجمعية الطبية الأمريكية (AMA)

Naji, al-Agli Abd al-Muhsin& Gaafre, Mohaimen. Dynamic penetration into glasspolyester laminates loaded with bi-axialforces. University of Thi-Qar Journal. 2008. Vol. 4, no. 3, pp.105-120.
https://search.emarefa.net/detail/BIM-276345

نوع البيانات

مقالات

لغة النص

الإنجليزية

الملاحظات

Includes appendices : p. 116-120

رقم السجل

BIM-276345