Improving wear properties of 392 al alloy using centrifugal casting

الملخص EN

The microstructure and wear properties of 392 Al alloy with different Mg contents were studied using centrifugal casting.

All melted alloys were heated to 800 ºC and poured into the preheated centrifugal casting mold (200-250 ºC) at different mould rotational speeds (1500, 1900 and 2300 r.p.m).

It is clear from the results obtained that wear rate was dependent on the Mg content, applied load and mould rotational speed.

Furthermore, wear test showed that the minimum wear rate was found in the inner layer of produced rings at mould rotational speed of 1900 r.p.m and Mg content of 5%.