Increase in the Tibial Slope in Unicondylar Knee Replacement: Analysis of the Effect on the Kinematics and Ligaments in a Weight-Bearing Finite Element Model

Abstract EN

Introduction.

Unicompartmental arthroplasty (UKA) of the knee in patients with isolated medial osteoarthritis yields adequate results; however, the survival rate is inferior to that of total knee arthroplasty (TKA).

A key factor in the longevity of the implant is the positioning; however, the optimal tibial slope in UKA has not been determined.

The aim of this study was to establish a finite element (FE) model and investigate the effect of the tibial slope on the strain of the ligaments, kinematics, inlay movement, and load in the nonreplaced patellofemoral compartment in a medial mobile bearing UKA.

Materials and Methods.

An FE model of a leg was established with a virtual UKA implantation with three different tibial slopes (0°, 5°, and 10°).

Subsequently, the knee was flexed from 14–73°.

In addition, the ground reaction force and the muscles were simulated.

Results.

With a higher tibial slope, there was more external rotation of the tibia.

An increased tibial slope provided a lateral shift of the patella in the trochlear groove and a more anterior position of the inlay.

The ligament strains were also changed, specifically, the anterior portion of the medial collateral ligament and the posterior cruciate ligament (PCL).

Discussion.

This study established the first model of a quasidynamic mobile bearing UKA in a leg under weight-bearing conditions.

With an increasing tibial slope, there was a higher external rotation of the tibia that created different femorotibial and retropatellar kinematics and different strains in the ligaments.

This knowledge adds important information for the optimal tibial slope that has to be determined individually depending on the patient’s preoperative kinematics, desired postoperative kinematics, ligament status, and location of the retropatellar chondral damage.