Coal Burst Induced by Horizontal Section Mining of a Steeply Inclined, Extra-Thick Coal Seam and Its Prevention: A Case Study from Yaojie No. 3 Coal Mine, China

Abstract EN

At present, coal bursts in working faces of steeply inclined coal seams (SICSs) have rarely been investigated, and current research focuses on the influences of roof breaking and instability of overlying structures in goaf on coal bursts; however, the stress state of coal masses in working faces being subjected to coal bursts is rarely researched.

To overcome the above defects, a model for analysing stresses on coal masses in horizontal section of SICSs was established based on the coal burst that occurred in LW5521-20, Yaojie No.

3 Coal Mine, Lanzhou, Gansu Province, China.

Moreover, the mechanism underpinning such a coal burst in SICSs was analysed based on the superposition mechanism of dynamic and static loads.

The results show that the side abutment pressure near the roof and floor under the horizontal sections of SICSs is asymmetrically distributed in the vertical direction in which the peak of side abutment pressure near the roof is closer to the working face and therefore is taken as the source of static loads for coal bursts in working faces.

When the superimposed dynamic load caused by hanging roof breaking and high static load borne in the coal masses is larger than the critical load for coal burst inception, a coal burst will occur.

Furthermore, the superimposed dynamic load induced by coal bursts on the support and the initial static load on the supports are larger than their limiting load, which leads to support collapse and eventually causes dynamic failure of the working face.

The coal burst in working faces in horizontal sections of SICSs can be prevented by using deep-hole presplit blasting in a hard roof, destress blasting in coal masses, and support optimisation of working faces, showing a favourable preventative effect.