Investigations on Actuator Dynamics through Theoretical and Finite Element Approach

Abstract EN

This paper gives a new approach for modeling the fluid-structure interaction of servovalve component-actuator.

The analyzed valve is a precision flow control valve-jet pipe electrohydraulic servovalve.

The positioning of an actuator depends upon the flow rate from control ports, in turn depends on the spool position.

Theoretical investigation is made for No-load condition and Load condition for an actuator.

These are used in finite element modeling of an actuator.

The fluid-structure-interaction (FSI) is established between the piston and the fluid cavities at the piston end.

The fluid cavities were modeled with special purpose hydrostatic fluid elements while the piston is modeled with brick elements.

The finite element method is used to simulate the variation of cavity pressure, cavity volume, mass flow rate, and the actuator velocity.

The finite element analysis is extended to study the system's linearized response to harmonic excitation using direct solution steady-state dynamics.

It was observed from the analysis that the natural frequency of the actuator depends upon the position of the piston in the cylinder.

This is a close match with theoretical and simulation results.

The effect of bulk modulus is also presented in the paper.